STEP 3
•
Place a battery into each headset,
by removing the outer sleeve on
the body of the headset using your
fingernail.
(figure 4)
•
Remove the tape over the battery
contacts, then slot the battery into the
chamber. It only goes in one way, so
turn it over if it won’t slide in. Clip the
sleeve back on. As soon as the battery
is connected the LED will flash BLUE
every second.
•
Place all headsets into the charger.
The headsets are now charging. The
LED on the headset will flash BLUE
every 10 seconds.
figure 4
figure 5
