ORIGINAL INSTRUCTIONS
250W
Electric Grass Trimmer
HELPLINE NO 03448010979
TECHNICAL DATA
Voltage
230–240V~ 50Hz
Power input
250W
No load speed
12000 /min
Max. cutting diameter
23cm
Diameter of line
1.4 mm
Line length
2*3m
Protection class
/II
Machine weight
1.64kg
NOISE AND VIBRATIOB DATA
A weighted sound pressure
84.8 dB(A) K: 1.03dB(A)
A weighted sound power
91.7dB(A)
Guaranteed sound power level
96dB(A)
Wear ear protection when sound pressure is over
80dB(A)
Typical weighted vibration
3m/s
2
, K: 1.5m/s
2
The declared vibration value has been measured in accordance with a standard test
method and may be used for comparing one product with another.
The declared vibration value may also be used to evaluate the exposure for the user caused
by vibration in advance.
WARNING:
The vibration emission value during actual use of the power tool can differ
from the declared value depending on the ways in which the tool is used dependant
on the following examples and other variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained
The use the correct accessory for the tool and ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti vibration accessories are used.
And the tool is being used as intended by its design and these instructions.
The declared vibration value has been measured in accordance with a standard test
method and may be used for comparing one product with another.
The declared vibration value may also be used to evaluate the exposure for the user caused
by vibration in advance.
This tool may cause hand-arm vibration syndrome if its use is not adequately managed
The declared vibration value has been measured in accordance with a standard test
method and may be used for comparing one product with another.
The declared vibration value may also be used to evaluate the exposure for the user caused
by vibration in advance.
WARNING:
To be accurate, an estimation of exposure level in the actual conditions of
use should also take account of all parts of the operating cycle such as the times when
