background image

  

  

15

14

  

  

Customer Helpline 

0845 034 2279

www.gardenservicecentre.co.uk

Customer Helpline 

0845 034 2279

www.gardenservicecentre.co.uk

Troubleshooting

General Troubleshooting

Storing the Grass Trimmer

Maintenance 

Maintenance Schedule

Step 1 - Storing the Grass Trimmer for Short Periods

• 

Drain all fuel from tank into a container approved for petrol. Run engine until it stops. Clean 

all foreign material from the trimmer. Store it in a well-ventilated place that is inaccessible to 

children. 

• 

Keep away from corrosive agents such as garden chemicals and de-icing salts. 

• 

Abide by all ISO and local regulations for the safe storage and handling of petrol. Excess fuel 

should be used up in other 2-Stroke engine powered equipment.

• 

Remove any coarse dirt.

• 

Wipe the machine with a soft damp cloth.

Step 2 - Storing the Grass Trimmer for Extended Periods

•  Clean air filter.
• 

Replace the spark plug with an exact replacement.

Performing routine maintenance correctly on your grass trimmer will ensure you get years of 

trouble free use.
Please keep this manual safe for future reference.
It is recommended that the following maintenance schedule is adhered to. This will ensure the 

grass trimmer operated correctly and is safe to use.

12 hours of use

24 hours of use

36 hours of use

Air filter

clean

clean

replace

Spark plug

check

clean

replace

List of consumable Qualcast parts

901305

air filter

901049

air filter cover

902700

spark plug L8RTF

901313

Fuel filter

901024

string line

902009

string head assy

These parts are available via www.gardenservicecentre.co.uk

CAUTION!

 

- Always switch off the engine and remove the high tension cable before starting any inspection 

or adjustment work.
- If, after making an adjustment or repair to the engine, you let it run for a few minutes, remember 

that the exhaust and other parts will get hot. 

Fault

Possible Cause

Solution

Engine not starting

1. Empty tank

2. Flooded engine

3. Fouled spark plug (remains of 

carbon on the electrodes) 

4. Electrode gap too large

5. Fouled carburetor or its jets 

6. Damaged spark plug connection 

or damaged spark plug 

1. Fill up

2. Close the throttle, pull cord several 

times, if required take out the spark 

plug and dry it   

3. Clean the spark plug, check its 

temperature, replace if needed. 

4. Adjust at 0.6-0.7 mm 

5. Clean the carburetor with air

6. Replace the spark plug.

 

Engine runs too fast 

when idle 

1. Cold engine 

1. Warm up slowly; alternatively 

apply the choke slightly. 

Engine does not 

reach its maximum 

speed 

1. Fouled spark plug (remains of 

carbon on the electrodes) spark 

gap to large 

2. Fouled carburettor or its jets 

3. Fouled air filter 

4.Exhaust, exhaust channel  

5. Sealing ring in crankcase not 

sealing properly 

6. Wrong fuel mix (too much oil) 

7. Bad ignition

1. Clean the spark plug, check its 

temperature, replace if needed. 

Adjust at 0.6-.07 mm.

2. Clean the carburettor with air

3. Clean

4. Take out the exhaust and clean it, 

remove remains of carbon 

5. contact customer helpline, 0845 

0342279

6. Fill up according to the instructions  

7. Adjust the ignition coil gap (0.3-0.4 

mm) 

Engine would not 

stop 

1. The switch failure 

2. High tension cable has become 

disconnected. 

1. Change the switch. 

2. Connect high tension cable to 

spark plug. 

The following table provides solutions to common problems encountered with the grass trimmer.

Summary of Contents for CDB30















Reviews: