Qualcast HQ-CG 3.6 Original Operating Instructions Download

Page: 14 / 18

When you fit the shrub cutter blade

Ensure the protective covers are fitted to
the blades before changing the blades
on the unit.
Check the position of the pin for the eccentric
connector (Fig. 7/Item 1). Take the shrub
cutter blade and slide the eccentric mount
(Fig. 8/Item 1) into position so that the pin for
the eccentric connector and the eccentric
mount fit together precisely when assembled.
Slot the shrub cutter blade onto the guide pins
(Fig. 7/Item 2).

When you fit the grass cutter blade

Ensure the protective covers are fitted to the
blades before changing the blades on the unit.
Check the position of the pin for the eccentric
connector (Fig. 7/Item 1) again. Shift the eccentric
mount (Fig. 9/Item 1) on the grass cutter blade to
the left or the right to find the position at which the
pin for the eccentric connector (Fig. 7/Item 1) and
the eccentric mount (Fig. 9/Item 1) match up.

7. Cleaning, maintenance and

ordering of spare parts

7.1 Cleaning

• Keep all safety devices, air vents and the

motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.

• We recommend that you clean the device

immediately each time you have finished
using it.

• Clean the equipment regularly with a moist

cloth and some soft soap. Do not use
cleaning agents or solvents; these could
attack the plastic parts of the equipment.
Ensure that no water can seep into the
device.

• A few drops of oil (e.g. sewing machine oil)

will improve the cutting performance of the
blades, but never apply any grease to the
blades. To ensure constant exact cutting it
is also important to remove grass remnants
and dirt from between the upper and lower
blade.

Important!
Never clean the tool under running water -
and particularly never with high pressure -
because of the potential danger to persons
and property. Keep your cordless grass
trimmer in a dry and frost-proof place.
Choose a place that children are unable
to enter.

7.2 Maintenance

• To achieve good results you should keep the

blades sharp at all times. In particular we
recommend that you immediately level off
any jags or ridges caused by stones or the
like. The tool should be thoroughly cleaned
both before and after use.

• There are no parts inside the equipment

which require additional maintenance.

7.3 Ordering replacement parts:

Please quote the following data when
ordering replacement parts:

• Type of machine (HQ-CG 3.6)
• Article number of the machine

34.104.39

• Identification number of the machine

11010

• Replacement part number of the part

required

For our latest prices and information please
go to www.einhell-uk.co.uk

Grass cutter blade: 341044001001
Shrub cutter blade: 341044001002

8. Disposal and recycling

The unit is supplied in packaging to prevent
its being damaged in transit. This packaging
is raw material and can therefore be reused
or can be returned to the raw material
system. The unit and its accessories are
made of various types of material, such as
metal and plastic. Defective components
must be disposed of as special waste. Ask
your dealer or your local council.

Helpline No. UK 0151 649 1500 / IRE 189 094 6244