6
FirEPlAcE iNSErt iNStAllAtiON:
The fireplace insert can be installed after the mantel has been fully assembled.
WARNING: Make sure the fireplace insert controls are in the OFF position and
the unit is NOT plugged in.
Step 17: Carefully place the insert into the unit opening. The front of insert should be
flush with the front of the mantel. See Fig. Q.
Fig. Q
BAcK
Step 18: Once the insert is in place, attach 2 L-mounting brackets [T] with 2 medium
KD screws [V] onto the base panel [B] (1 screw for each bracket). Attach 3
short KD screws [U] to the top of insert. See Fig. R.
Fig. R
BAcK
Step 19: Tighten all KD screws.
Step 20: Carefully move the assembled unit to the desired location. The fireplace
mantel should not be positioned in area exposed to direct sunlight.
WAll ANcHOr SAFEtY cABlE
The use of wall anchor safety cable is highly recommended in order to reduce the risk
of the fireplace being tipped over accidentally.
WARNING: This cable may reduce possible risk of injury if the fireplace is
improperly handled, but is not a substitute for proper adult supervision.
Children should not be left unattended near any heater.
Step 1: Drill a 5/16 in (8 mm) hole in the wall. Insert the plastic wall anchor into the
hole and gently tap until the flange on the anchor is against the wall surface.
Step 2: Position the back edge of the mantel close to the wall.
Step 3: Attach the safety cable to the mantel using the screw for mantel.
Step 4: Use the screw for wall to attach the other end of safety cable to the wall.
Step 5: Make sure all screws are tight.
Fig. S
BAcK
WARNING: Ensure the safety cable is attached to the back of the unit to avoid
tip over.
OPErAtiON
After reading complete instructions, confirm all controls on fireplace are in the OFF
position. Plug the fireplace into a 15AMP/120 Volt outlet. If the cord does not reach,
you may use an extension cord rated for a minimum of 1875 WATTS. Once the fireplace
insert has been properly connected to a grounded electrical outlet, it is ready to operate.
OPErAtiON BY tHE cONtrOl PANEl
The controls are located behind the grill below the front glass and can be accessed by
pulling the grill from the top, forward and down.
WARNING: Do not touch hot surface at centre of grill. Hold left and right side of
the grill when pulling out.
0/I:
Press this button for main power and flame effect. The indicator light will be on. See
below for other control switches.
