background image

1

design forward living

Model:  MW914T-35BK

ElEctric FirEPlAcE 

HEAtEr

IMPORTANT:
PleAse NOTe: WheN yOu OPeN The cARTON, cARefully checK The uNIT 

ANd MAKe suRe TheRe Is NO dAMAge. If yOu hAve ANy PROBleMs WITh 

AsseMBlINg The uNIT, WITh hOW The vARIOus fuNcTIONs WORK OR WITh 

dAMAge OR MIssINg PARTs PleAse cAll 1-800-459-4409 (MONdAy TO 

fRIdAy, 8:30AM TO 5:00PM, esT) IMMedIATely fOR seRvIce. 
NOTe: dO NOT ReTuRN uNIT TO The sTORe BefORe cAllINg The TOll fRee 

NuMBeR. dO NOT dIsPOse Of yOuR cARTONs uNTIl yOu ARe cOMPleTely 

sATIsfIed WITh yOuR NeW elecTRIc fIRePlAce heATeR.
NOTe:

 Light bulbs may become loose during shipping. If the flame effect is dim or does 

not work, please check that light bulb or bulbs are finger tight in socket. See instructions 
for replacing bulb or bulbs. 
 

iNStrUctiON MANUAl

ATTeNTION: 

1)   Find a location for the electric fireplace heater that is protected from direct sunlight.
2)  Do not plug the unit into the power outlet before reading all instructions.

iMPOrtANt SAFEtY iNStrUctiONS

WheN usINg elecTRIcAl APPlIANces, BAsIc PRecAuTIONs shOuld AlWAys 

Be fOllOWed TO Reduce The RIsK Of fIRe, elecTRIc shOcK, ANd INJuRy 

TO PeRsONs, INcludINg The fOllOWINg:

1)   Read all instructions before using this electric fireplace heater.
2)   This electric fireplace heater is hot when in use. To avoid burns, do not let 

bare skin touch hot surfaces. Keep combustible materials, such as furniture, 
pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9 m) away 
from the front of the unit and keep them away from the sides and rear. 

3)   extreme caution is necessary when any heater is used by, or near, children  

or individuals with disabilities and whenever the fireplace is left operating  
and unattended. 

4)   Always unplug fireplace when not in use.
5)   do not operate any electric fireplace heater with a damaged cord or plug or 

after the heater malfunctions, has been dropped or damaged in any manner. 

6)   do not use outdoors. 
7)   This electric fireplace heater is not intended for use in bathrooms, laundry 

areas and similar indoor locations. Never locate heater where it may fall into 
a bathtub or other water container. 

8)   do not run cord under carpeting. do not cover cord with throw rugs, runners, 

or similar coverings. Arrange cord away from traffic area and where it will 
not be tripped over. 

9)   To disconnect fireplace, turn controls to off, then remove plug from outlet. 
10)  connect to properly grounded outlets only.
11)   do not insert or allow foreign objects to enter any ventilation or exhaust 

opening as this may cause an electric shock or fire, or damage the heater. 

12)   To prevent a possible fire, do not block air intakes or exhaust in any manner. 

do not use on soft surfaces, like a bed, where openings may become 
blocked. 

13)   A heater has hot and arcing or sparking parts inside. do not use it in areas 

where gasoline, paint, or flammable liquids are used or stored. 

14)   use this electric fireplace heater only as described in this manual. Any other 

use not recommended by the manufacturer may cause fire, electric shock, or 
injury to persons. 

15)   Avoid the use of an extension cord because the extension cord may overheat 

and cause a risk of fire. however, if you have to use an extension cord, the 
cord shall be No. 14 AWg minimum size and rated not less than 1875 watts.

16)   caution: do not plug this product into a receptacle controlled by a wall switch 

or dimmer.

17)   When storing or transporting the unit and cord, keep in a dry place, free from 

excessive vibration and store so as to avoid damage.

SAVE tHESE iNStrUctiONS  
FOr FUtUrE USE.

cAuTION:
If yOu use ThIs heATeR IN cONJuNcTION WITh A TheRMAl cONTROl, A 

PROgRAM cONTROlleR, A TIMeR OR ANy OTheR devIce ThAT sWITches The 

heATeR ON AuTOMATIcAlly, ReMeMBeR TO OBseRve All sAfeTy WARNINgs 

AT All TIMes. The elecTRIc fIRePlAce heATeR hAs sAfeTy OveRheAT 

PROTecTION. If The OveRheAT PROTecTION TRIPs, sWITch Off All sWITch 

BuTTONs ANd WAIT APPROxIMATely 5 -10 MINuTes. IT shOuld ReseT 

AuTOMATIcAlly ONce The uNIT cOOls dOWN.
WARNINg:
PROceduRes ANd TechNIques If NOT cARefully fOllOWed WIll ResulT 

IN dAMAge TO The equIPMeNT ANd WIll exPOse The useR TO The RIsK Of 

seRIOus INJuRy, IllNess OR deATh. 
ThIs elecTRIc fIRePlAce heATeR Is fOR use ON 120 vOlTs. The cORd hAs 

A Plug As shOWN AT A IN IllusTRATION BelOW. AN AdAPTeR As shOWN AT 

c Is AvAIlABle fOR cONNecTINg ThRee-BlAde gROuNdINg-TyPe Plugs TO 

TWO-slOT RecePTAcles. The gReeN gROuNdINg Plug exTeNdINg fROM 

The AdAPTeR MusT Be cONNecTed TO A PeRMANeNT gROuNd such As A 

PROPeRly gROuNded OuTleT BOx. The AdAPTeR shOuld NOT Be used If A 

ThRee-slOT gROuNded RecePTAcle Is AvAIlABle. 
A 15 AMP cIRcuIT Is RequIRed TO OPeRATe ThIs heATeR. If The BReAKeR 

TRIPs WheN The heATeR Is used TheN yOu MAy Need TO MOve The heATeR 

TO ANOTheR lOcATION OR uNPlug OTheR APPlIANces ThAT ARe ON The 

sAMe cIRcuIT. If yOu RequIRe AN exTeNsION cORd use ONe ThAT Is RATed 

AT 1875 WATTs. 

Summary of Contents for MW914T-35BK

Page 1: ...ols to off then remove plug from outlet 10 Connect to properly grounded outlets only 11 Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire or damage the heater 12 To prevent a possible fire do not block air intakes or exhaust in any manner Do not use on soft surfaces like a bed where openings may become blocked 13 A heater...

Page 2: ...ng complete instructions confirm all controls on fireplace are in the OFF position Plug the fireplace into a 15AMP 120Volt outlet If the cord does not reach you may use an extension cord rated for a minimum of 1875 watts Once the fireplace unit has been properly connected to a grounded electrical outlet it is ready to operate OPERATION BY THE CONTROL PANEL The controls are located on the top of th...

Page 3: ...MENT Replace with 2 AAA batteries WARNING Do not mix old and new batteries Do not mix alkaline standard Carbon Zinc or rechargeable Nickel Cadmium batteries MAINTENANCE WARNING Disconnect power and unplug the power cord before attempting any maintenance or cleaning to reduce the risk of fire electric shock or damage to persons The bulbs in your unit can become extremely hot Allow at least 10 minut...

Page 4: ...or replace the unit This warranty is void if in the opinion of Quality Craft the unit has been tampered with altered misused damaged abused or used with the wrong power source Light bulbs and remote batteries are not covered by this warranty The warranty is for homeowner use only and does not cover units used in commercial situations Warranty Claim Procedure If a claimable defect occurs please fil...

Reviews: