![background image](http://html2.mh-extra.com/html/qualstar/q40/q40_installation-and-operation-manual_3430585118.webp)
Q40 Tape Library
Installation and Operations Manual
511026 Rev. 07-01-19
118
6.19.2.5
Network Status
To see the configuration and status of the library’s network settings navigate to the
Status > Network
Status
page
.
On the network status page you can see:
•
Host Name
– Library hostname
•
Domain Name
•
Protocol
– IPV4 or IPv6
•
MAC Address
– A unique identifier for the library controller network interface
•
Link Status
– Enabled or disabled
•
Link Speed
– Speed of the Ethernet connection to the library
•
Duplex
– Enabled or disabled
IPv4 settings
•
DHCP
– When Enabled, the library requests an IP address from a DHCP server each time
the library is powered on.
•
Address
– IP address in use by the library. If DHCP is enabled, this address was obtained
from the DHCP server. When DHCP is not enabled, the address was configured.
•
Netmask
– The network mask of the library controller used when DHCP is not enabled.
•
Gateway
– The gateway used when DHCP is not enabled.
•
DNS 1
•
DNS 2
IPv6 settings
•
Stateless Addressing
– When Enabled, the device will generate an address for itself based
on the routing information obtained from a router advertisement and the MAC address. The
device can manage up to five global addresses at the same time, which can be assigned
from different routers.
•
Static Addressing
– When Enabled, the library will use a statically-configured address.
•
Static Assigned Address
– The IPv6 address when Static Addressing Enabled is On.