7-70
Field
–
Replaceable Units (FRUs)
501510 Rev. S
7.22.1
Fixed Slot Removal
1.
Remove the Carriage Assembly from the RLS as described in Section 7.7.1.
2.
Using a No. 1 Phillips screwdriver, remove the two Fixed Slots mounting screws.
Remove the Fixed Slot. Repeat this step for the remaining Fixed Slots.
7.22.2
Fixed Slot Replacement
1.
Position the Fixed Slot in the library so that the end of the Fixed Slot with the
notches is facing up.
2.
Align the mounting holes in the Fixed Slot with the threaded holes in the RLS
and using a No. 1 Phillips screwdriver, replace the two pan-head screws that
were removed earlier. Repeat this step for the remaining Fixed Slots.
3.
Reinstall the Carriage Assembly into the RLS as described in Section 7.
4.
Proceed to Section 7.24 to calibrate the RLS.
7.23
Air Filter
P/N 510096-01-9
Front Panel/Door
Right Side Slot
Left Side Slot
Air Filter Element
Center Rib
Notch in
Air Filter
Lip in
Front Panel/Door
Figure 7-45 Air Filter with the Front Panel/Door Open
Summary of Contents for RLS-4470
