13.3 Scanning the Inventory and Locking the Doors
13-6
501801 Rev. 07-01-19
14.
Refer to
for instructions for scanning the inventory
and locking the doors.
13.3
Scanning the Inventory and Locking the Doors
After scanning the fiducials, you can scan the barcode labels on any cartridges installed in
the slots to establish the library’s inventory. To scan the inventory, follow these steps:
1.
Access the View/Edit Hardware Configuration page as described in
.
2.
Select
Scan Inventory
from the Inventory section of the page.
3.
Wait while the handler scans the barcode label on each cartridge, then select
Sync Inventory
to update the logical library inventories with the results of the
physical library scan.
4.
From the Misc section of the page, select
Lock Doors
. The Lock Doors page
opens, as shown in
5.
Press
Lock Doors.
The library performs the following actions:
–
It engages the solenoids controlling the electronic door locks.
– It stops flashing the yellow Attention LED.
Note:
If one or more I/O ports are open, the LED remains on but does not flash.
– If any of the light curtain sensors have been violated, it rescans the cartridges
in the affected areas.
Important:
Depending on the number of magazines in your library,
scanning all slots can take several hours.
Figure 13-6
Lock Doors page
Summary of Contents for XLS-810160
