5.3 Releasing the Carousel Locks in a XLS-85000 MEM
5-4
501801 Rev. 07-01-19
You need to remove the inner hard stop on the left side where you will install the MEM.
To remove an inner hard stop, follow these steps:
1.
You will install a MEM to the left of the LRM, so locate the inner hard stop on the
left side of the X-axis.
2.
Using a 5/32-inch Allen wrench, remove the appropriate inner hard stop from the
X-axis. See
5.3
Releasing the Carousel Locks in a XLS-85000 MEM
To release the carousel locks, follow these steps:
CAUTION
To avoid damage to the equipment, never remove the two outer stops.
Figure 5-5
X-axis hard stop removed (left side shown)
CAUTION
The carousel in the XLS-85000 MEM is locked into place for shipping.
You must release the carousel locks before installing the MEM.
Inner hard stop removed
Outer hard stop
Summary of Contents for XLS-810160
