6
Installing an Expansion Pod
XLS Library Installation Manual
6-7
6.3
Removing the X-Axis Hard Stop
When shipped, the X-axis (horizontal axis) on the handler includes two inner and two
outer “hard stops,” which are simply #10 cap screws located at each end of the X-axis. See
When the inner hard stops are installed, the handler is prevented from traveling too far to
the left and right. When an inner hard stop is removed, the handler can reach into an
attached expansion pod.
You need to remove the inner hard stop on the left side where you will install the
expansion pod.
To remove an inner hard stop, follow these steps:
1.
You will install a expansion pod on the left side of the LRM, so locate the inner
hard stop on the left side of the X-axis.
Figure 6-9
Outer and inner hard stops on the handler’s X-axis (left side shown)
CAUTION
To avoid damage to the equipment, never remove the two outer stops.
Inner hard stop
Outer hard stop
Summary of Contents for XLS-810160
