![background image](http://html2.mh-extra.com/html/qualstar/xls-series/xls-series_technical-and-service-manual_3471239089.webp)
5
Using X-Link Service Options
XLS Library Technical Service Manual
5-75
Section
Option
Use option to...
Fiducials
Scan Magazine Fiducials
Scan the fiducials on all storage magazines
Scan I/O Port Fiducials
Scan the fiducials on the I/O port magazines and scan the
inventory of each port
Scan/Calibrate Tape Drives Scan and calibrate the tape drive locations
Scan Unscanned Fiducials
Based on the results of Dump Fiducial Database (see
below), scan any fiducials that were missed during the
magazine, I/O port, and tape drive scans
Calibrate Fiducials
Based on the results of the fiducial scan operations,
calculate the positions of the fiducials for the cartridge
magazines and I/O ports
Dump Fiducial Database
Display the database of fiducial information to establish
whether any fiducials were missed during the fiducial scans
Carousels
Power Off Carousel Left
Power off the left or right carousel controller before
replacing the carousel motor. See
Section 15.3.1 on
page 15-23
.
Power Off Carousel Right
Power On Carousel Left
Power on the left or right carousel controller after replacing
the carousel motor. See
Section 15.3.4 on page 15-30
.
Power On Carousel Right
Table 5-2
Options on the Service Utilities page (
continued
)
5.6
Changing the Configuration
This section describes how to perform the following Change Configuration procedures
from the Service portlet:
•
Upload File (see
Section 5.6.1
)
•
Install File (see
Section 5.6.2 on page 5-19
)
•
View SCSI Log Setting (see
Section 5.6.3 on page 5-20
)
Important:
The
View/Edit Hardware Configuration
selection is
used only after a hardware part is installed or replaced.
For instructions on using this option, refer to the
appropriate FRU replacement procedure
.
Summary of Contents for XLS Series
