FUNCTION OPERATION AND DESCRIPTION
FUNCTION OPERATION AND DESCRIPTION
⊙
FUNCTION OPERATION AND DESCRIPTION（The following description is without
voice prompt.）
Auto Keypad Lock（AUTOLK）——Menu No.24
1. In frequency or channel mode, press Menu+24, the LCD displays:
2. Press key Menu, and then press key ▲ or ▼ to choose, the LCD displays:
ON：ON OFF: OFF
3. After setting, press key Menu to confirm, and then press key PTT or Exit to standby.
If you set on, the LCD displays:
When power on, but the radio is not in the working mode, the keypad will be automatically
locked after 15s.
The operation steps are as follows:
!
NOTE
You should set different
frequency deviation
according to the repeaters
selected.This function is
invalid in channel mode.
⊙
Frequency Offset Direction Setting（SFT-D）——Menu No.25
1. In frequency mode, press Menu+25, the LCD displays:
2. Press key Menu, and then press key ▲ or ▼ to choose, the LCD displays:
The frequency deviation mode：
a. Transmitting frequency higher than receiving fre）；
b. Transmitting frequency lower than receiving frequency（-）；
c. OFF
3. After setting, press key Menu to confirm, and then press key PTT or
Exit to standby.
When you set the frequency deviation (+), the LCD displays:
When you set the frequency deviation (-), the LCD displays:
Using this function, you may set different receiving and transmitting frequencies. In general, it’s
used for repeater.
The operation steps are as follows:
FUNCTION OPERATION AND DESCRIPTION（The following description is without
voice prompt.）
Frequency Deviation（OFFSET）——Menu No.26
1. In frequency mode, press Menu+26, the LCD displays:
2. Press key Menu, and then input your desired deviation frequency.
If you want to input the frequency deviation 5MHz, pls input numbers 0、5、0、0、0 directly.
3. After setting, press key Menu to confirm, and then press key PTT or Exit to standby.
Using this function, you can set the deviation between receiving and transmitting frequency.
In general, this function is used for repeater. The frequency deviation of this radio is：0-69.990MHz.
The operation steps are as follows:
!
NOTE
Setting the frequency offset direction. (See Menu No.25)
⊙
Channel Store （MEM-CH）——Menu No.27
1. In frequency mode, press Menu+27, the LCD displays:
2. Press key Menu, and then press key ▲ or ▼ to choose channel number, or you can input your
desired channel number directly.Fox example, if you want to input No. 25 channel, pls input number
0、2、5 directly.
3. After setting, press key Menu to confirm, and then press key PTT or Exit to standby.
Example：Channel 1（Same frequency） Receiving frequency: 465.875 MHz CTCSS: 71.9 Hz
Transmitting frequency: 465.875 MHz CTCSS: 71.9 Hz
Channel 2（different frequency）Receiving frequency: 465.575 MHz
Transmitting frequency: 460.575 MHz CTCSS: 88.5 Hz
When the radio is in frequency working mode or standby mode, input the desired frequency or
parameters directly.
The operation steps are as follows:
AUTOLK
OFF
24
AUTOLK
ON
24
400.875
136.225
SFT-D
OFF
25
25
SFT-D
+
400.875
136.225
+
400.875
136.225
-
OFFSET
00.000
26
MEM-CH
000
27
35
36
Summary of Contents for TG-007
Page 1: ...USER S MANUAL TG 007 0700...
