Chapter 3
42
KEMB-8100 & ATX-KLS0 Series User’s Manual
Chapter 3
System Installation
Expansion Interfaces
4x PCI slot, 1x PCIex16 slot, 2x PCIex1 (H110 models) or 2
PCIex4/PCIex2/PCIex1 (Q170 models)
1x mPCIe socket (H110 models) / 2x mPCIe/mSATA socket (Q170 models)
1x SIM card holder
NOTE
When adding or removing expansion cards, make sure that you unplug the
power supply first. Meanwhile, read the documentation for the expansion card
to configure any necessary hardware or software settings for the expansion
card, such as jumpers, switches or BIOS configuration.
Memory Module Installation
Carefully follow the steps below in order to install the DIMMs:
1. To avoid generating static electricity and damaging the DIMM, ground yourself by
touching a grounded metal surface or use a ground strap before you touch the
DIMM.
2. Do not touch the connectors of the DIMM. Dirt or other residue may cause a
malfunction.
3. Spread apart the ejector tabs on each end of the DIMM socket.
4. Hold the DIMM with its notch aligned with the onboard socket and insert it
straight down into the socket.
5. Fully insert the module into the socket until the ejector tabs pop up and a “click”
is heard.
