NWA-6500 Series - User Guide, Rev. 1.4
// 36
7.1.
DC Power Connection
The NWA-6500 Series is connected by a DC power input jack (Figure 2, pos. 1) to a DC power source or by a 2-pin
Phoenix connector (Figure 2, pos. 2, only the Phoenix power plug terminal is included) via a DC power supply wiring.
For the models with DC power input jack, the NWA-6500 Series is delivered with a power adapter to convert AC
voltage into a DC voltage within the range from 12V to 19V depending on the ordered configuration and a power cord
to carry AC power to the power adapter.
For the models with 2-pin Phoenix connector, the NWA-6500 Series is delivered with a 2-pin Phoenix power plug
terminal. For DC connection, prepare the connecting wires using the supplied Phoenix plug terminal. DC power
voltage should be within the range from 19V to 36V.
Figure 11: Phoenix power plug terminal
1
Slotted pan head screw for securing the wire
2
Slotted pan head screw for securing the Phoenix plug terminal to the Phoenix connector
3
Location for inserting the positive (+) input wire
4 Location for inserting the negative (-) input wire
7.1.1.
Cabling
For the pin assignment Phoenix power plug terminal refer to the subsection 11.1.2 "Phoenix Connector".
1.
Cut the required length two isolated wires ( 1mm2) AWG 18 and strip each end 5 ~ 7 mm.
2.
Twist the striped wire-ends and provide them with ferrules.
3.
Loosen the two slotted pan head screws of the DC plug terminal far enough so that you can insert the end of the
prepared wires.
4.
Insert the wires into the corresponding clamp of the Phoenix plug terminal. Make sure that you have the right
polarity of the connection [refer to Figure 11 or subsection 11.1.2 "Phoenix Connector"].
5.
Fasten the screws to secure the wires into the clamps of the plug terminal.
1
1
2
2
3
4
