29
English
3.2 Main
System Time
This setting allows you to set the system time. The time format is <Hour> <Minute>
<Second>.
System Date
This setting allows you to set the system Date. The time format is <Day> <Month> <Date>
<Year>.
Primary IDE Master/Slave, SATA 1/2
[Type]
Press PgUp/<+> or PgDn/<-> to select
[Manual], [None] or [Auto] type. Note that the specifications
of your drive must match with the drive table. The hard disk
will not work properly if you enter improper information for this
category. If your hard disk drive type is not matched or listed,
you can use [Manual] to define your own drive type manually.
[LBA/Large Mode]
Enabling LBA causes Logical Block Addressing to be used in
place of Cylinders, Heads and Sectors.
[Block (Multi-Sector
Transfer)]
Any selection except Disabled determines the number of sec-
tors transferred per block.
[PIO Mode]
Indicates the type of PIO (Programmed
Input/Output)
[DMA Mode]
Indicates the type of Ultra DMA
[S.M.A.R.T.]
This allows you to activate the S.M.A.R.T.
(Self-Monitoring Analysis & Reporting Technology) capabil-
ity for the hard disks. S.M.A.R.T is a utility that monitors your
disk status to predict hard disk failure. This gives you an op-
portunity to move data from a hard disk that is going to fail to
a safe place before the hard disk becomes offline.
[32 Bit Data Transfer] Enables 32-bit communication between
CPU and IDE controller
