RAK-120S - User Guide, Rev. 1.0
// 33
7.1.
System Mounting
In order to adapt the RAK-120S for mounting we offer the following mounting solution:
RAK-120S configuration with a rackmount kit for horizontal installation into a rack / cabinet.
Depending on the ordered RAK-120S configuration, your system may be supplied with a rackmount server slide kit
(Figure 8). The kit consists of one piece of left-hand server slide (Figure 8, pos. R), one piece of right-hand server slide
(Figure 8, pos. L), four pieces of M5 screws for ear plate fastening, and two pieces of M4 screws for chassis fastening.
Each slide is composed of a chassis (inner) slide rail and a cabinet (outer) slide rail.
Figure 8: Optional rackmount server slide kit
To mount the RAK-120S please proceed according to the steps described:
Start installation from the bottom of the rack cabinet.
The heaviest device should be placed in the bottom of the rack cabinet.
Remove the rack door(s) and slide panels for easy installation.
1.
Pull the slide open. Then press the trigger down to release the chassis (inner) slide rail from the cabinet (outer)
slide rail. Pull the chassis (inner) slide rail out.
Figure 9: Removing the chassis (inner) slide rail
