RAK-120S - User Guide, Rev. 1.0
// 62
Figure 29: BIOS Advanced Menu - Serial Port Console Redirection - COM1 Console Redirection Settings*
BIOS SETUP UTILITY
Main
Advanced
Power
Boot
Security
Save & Exit
COM1
Console Redirection Settings
Terminal Type
[ANSI]
Bits per second
[115200]
→
←
: Select Screen
Data Bits
[8]
↑
↓
: Select Item
Parity
[None]
Enter: Select
Stop Bits
[1]
+/-: Change Opt.
Flow Control
[None]
F1: General Help
VT-UTF8 Combo Key Support
[Enabled]
F2: Previous Values
Recorder Mode
[Disabled]
F3: Optimized Defaults
Resolution 100x31
[Disabled]
F4: Save & Exit
Putty KeyPad
[VT100]
ESC: Exit
Version 2.19.1266. Copyright (C) 2019, American Megatrends, Inc.
* This submenu appears only when enabling console redirection of COM1 in the previous higher menu.
Feature
Option
Description
Terminal Type
[VT100], [VT100+],
[VT-UTF8], [ANSI]
Emulation:
ANSI: Extended ASCII char set.
VT100: ASCII char set.
VT100+: Extends VT100 to support color, function keys, etc.
VT-UTF8: Uses UTFb encoding to map Unicode
Bits per second
[9600], [19200],
[38400], [57600],
[115200]
Select serial port transmission speed. The speed must be
matched on the other side. Long or noisy lines may require
lower speeds.
Data Bits
[7], [8]
Select data bits.
Parity
[None], [Even], [Odd],
[Mark], [Space]
A parity bit can be sent with the data bits to detect some
transmission errors.
Even: parity bit is 0 if the number of 1's in the data bits is even.
Odd: Parity bit is 0 if the number of 1's in the data bits is odd.
Mark: Parity bit is always 1.
Space: Parity bit is always 0.
Stop Bits
[1], [2]
Stop bits indicate the end of a serial data packet. (A start bit
indicates the beginning). The standard setting is 1 stop bit.
Communication with slow devices may require more than 1 stop
bit.
Flow Control
[None], [Hardware
RTS/CTS]
Flow control can prevent data loss from buffer overflow. When
sending data, if the receiving buffers are full, a 'stop' signal can
be sent to stop the data flow. Once the buffers are empty, a
'start' signal can be sent to re-start the flow.
VT-UTF8 Combo Key
Support
[Disabled], [Enabled]
Select whether to enable or disable VT-UTF8 Combination Key
Support for ANSI/VT100 terminals.
Recorder Mode
[Disabled], [Enabled]
With this mode enabled only text will be sent. This is to capture
