QuanSheng TG-45UV, User Manual

FUNCTION OPERATION AND DESCRIPTION

FUNCTION OPERATION AND DESCRIPTION

FUNCTION OPERATION AND DESCRIPTION（The following description is without
voice prompt.）

Scan Resumed Mode（SC-REV）——Menu No.18

1. In frequency or channel mode, press Menu+18, the LCD displays: 
2. Press key Menu, and then press key ▲ or ▼to choose，the LCD displays:
   There are three ways of scanning.
   TO：Time scanning，continue to scan after searching signal for 5s.
   CO：Carrier scanning，when it searches the signal, it continues to scan after the signal disappears.
   SE：Search scanning，stop scanning once searching the signal.
3. After setting, press key Menu to confirm, and then press key PTT or Exit to standby.

This function can scan activities from other radios

’

 frequencies or channels. You can select the scan 

mode according to your request.

The operation steps are as follows:

!

NOTE

Select“off”in 
normal use to
avoid affecting 
the radio.

⊙

PTT ID（PTT-ID）——Menu No.19

1. In frequency or channel mode, press Menu+19, the LCD displays:
2. Press key Menu, and then press key ▲ or ▼ to choose, the LCD displays:
   There are four kinds of mode：
   OFF：not send.
   BOT：Press PTT key to send code.(The PTT-ID is set by software)
   EOT：Release PTT key to send code.
   BOTH：Press or release PTT key to send code.
3. After setting, press key Menu to confirm, and then press key PTT or Exit to standby.

This funcition can set the sound of sending PTT-ID when you press key PTT  or release it.

The operation steps are as follows:

FUNCTION OPERATION AND DESCRIPTION（The following description is without

voice prompt.）

DTMFST（DTMFST）——Menu No.16

This function is that when the radio transmits, the recipient can hear the DTMF and ANI-ID code issued 
by the radio.

!

NOTE

Do not use this function if not necessary in case to affect the radio.

⊙

Signal Code（S-CODE）——Menu No.17

1. In frequency or channel mode, press Menu+17, the LCD displays:
2. Press key Menu, and then press key ▲ or ▼ to choose，the LCD displays: 
3. After setting, press key Menu to confirm, and then press key PTT or Exit to standby.
 

This  function  is  to  set  radio  signal  code,  it  can  set  1-15  groups.  This  function  can  just  be  set  by 
program software.

The operation steps are as follows:

1. In frequency or channel mode, press Menu+16, the LCD displays:
2. Press key Menu and then press key ▲ or ▼ to choose, the LCD displays: 
   Choose mode: OFF： OFF
   DT-ST：When transmitting, manually press keypads to make DTMF sound.
   ANI-ST：When transmitting, it automatically makes DTMF sound.
   DT+ANI：When transmitting, manually press keypads or automatically makes DTMF sound.
3. After setting, press key Menu to confirm, then press PTT or Exit to standby.

The operation steps are as follows:

!

NOTE

Select“OFF”when using in case to affect the radio.

⊙

16

DTMFST  

OFF

16

DTMFST

  DT-ST

17

S-CODE  

1

17

S-CODE

  13

SC-REV  

T0

18

SC-REV

  SE

18

PTT-ID  

OFF

19

PTT-ID

  BOT

19

31

32