R
EGULATORY
AND
C
OMPLIANCE
I
NFORMATION
E
LECTROMAGNETIC
C
OMPATIBILITY
N
OTICES
4-1
4.1 Electromagnetic Compatibility Notices
FCC Verification Statement (USA)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference when the equipment is operated in a com-
mercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
Europe (CE Declaration of Conformity)
This product has been tested in accordance too, and complies with the Low voltage Direc-
tive (2006/95/EC) and EMC Directive (2004/108/EC). The product has been marked with
the CE Mark to illustrate its compliance.
VCCI (Japan)
この裝置は、クラス A 情報技術裝置です。この裝置を家庭環境で使用すると電波妨害を引き起こす
ことがあります。この場合には使用者が適切な対策を講ずるよう要求されることがあります。
VCCI-A
English translation of the notice above:
This is a Class A product based on the standard of the Voluntary Control Council for Interference (VCCI) from
Information Technology Equipment. If this is used near a radio or television receiver in a domestic environ-
ment, it may cause radio interference. Install and use the equipment according to the instruction guide.
BSMI (Taiwan)
The BSMI Certification Marking and EMC warning is located on the outside rear area of the
product
警告使用者：
此為甲類資訊技術設備，於居住環境中使用時，可能會造成射頻擾動，在此種情況下，使用者會被要
求採取某些適當的對策。
