BMC
C
ONFIGURATION
G
ROUP
4-
20
Procedure:
Entering the details in Advanced Active Directory Settings Page
1. Click on
Advanced Settings
to open the Advanced
Active Directory Settings Page.
F
Advanced Active Directory Settings Page
2. In the Active Directory Settings Page, enter the following
details.
3.
Active Directory Authentication:
To enable/disable
Active Directory, check or uncheck the
Enable
checkbox
respectively.
4. Specify the Domain Name for the user in the
User
Domain Name
field. e.g. MyDomain.com
5. Specify the time (in seconds) to wait for Active Directory
queries to complete in the
Time Out
field.
6. Configure IP addresses in
Domain Controller Server
Address1, Domain Controller Server Address2 &
Domain Controller Server Address3
.
7. Click
Save
to save the entered settings and return to
Active Directory Settings Page.
8. Click
Cancel
to cancel the entry and return to Active
Directory Settings Page.
To add a Role Group
Note:
If you have enabled Active Directory Authentication, enter the
required information to access the Active Directory server.
Note:
Default Time out value: 120 seconds.
Range from 15 to 300 allowed.
Note:
IP address of Active Directory server: At least one Domain Con-
troller Server Address must be configured.
IP Address made of 4 numbers separated by dots as in
"xxx.xxx.xxx.xxx".
Each number ranges from 0 to 255.
First number must not be 0.
Note:
Domain Controller Server Addresses will supports IPv4
Address format and IPv6 Address format.
Summary of Contents for STRATOS S210 Series S210-X2A2J
