Wid:
Set the desired pulsewidth.
Mode:
Select the Normal mode.
Pressing the RUN/STOP key will now generate a continuous stream of pulses.
To Use Channel Single Shot Function
The Single Shot mode generates a single pulse every time the RUN/STOP key
is pressed. If the unit is in the active state, ( i.e. channels which are set to the
Normal mode are producing pulses), pressing the FUNC key and RUN/
STOP key will reset the Single Shot counters and generate one pulse in sync
with the other channels running in the Normal mode. To use the Single Shot
mode:
- within the Channel menus
Enable
Select Enable to enable channel output.
Delay
Set the desired delay.
Width
Set the desired pulsewidth.
Mode
Select the Single shot mode.
To Use Channel Burst Mode Function
The Burst mode generates a burst of pulses every time the RUN/STOP key is
pressed. If the unit is in the active state, (i.e. channels which are set to the
Normal mode are producing pulses), pressing the FUNC- RUN/STOP key
sequence will reset the Burst counters and generate a new set of pulses in sync
with the other channels running in the Normal mode. FUNC - RUN/STOP will
not affect T
o
pulse status. To use the Burst mode:
-within the Channel menus
Enable
Select Enable to enable channel output.
Delay
Set the desired delay.
Width
Set the desired pulsewidth.
Mode
Select the Burst mode.
#/Burst
Set the number of pulses to produce in the burst.
To Use the Channel Duty Cycle Function
To generate a stream of pulses which oscillates on for n pulses and off for m
pulses:
- within the Channel menus
Enable
Select Enable to enable channel output.
Delay
Set the desired delay.
Width
Set the desired pulsewidth.
Mode
Select the Duty Cycle mode.
On Cycle
Set the number of pulses to produce during the on
cycle.
Off Cycle
Set the number of pulses to skip during the off cycle.
