Manual for ZillioX 6
AGP VGA Connector
This connector should be connected to a standard monitor if the on-board AGP VGA is
used (refer to
Jumper Settings
for detailed information on enabling/disabling AGP).
Power Supply Connector(J10,J11) & Power Switch (POWER)
ATX/SFX power supply can both be used on this system. Be sure to connect the power
supply plug to connector J10 in the proper orientation. The power switch (POWER) should
be connected to a momentary switch. W hen powering up your system, first turn on the
mechanical switch of the power supply (if one is provided), then push once the button of
the power switch. W hen powering off the system, you needn’ t turn off the mechanical
switch, just
push once
*
the button of the power switch.
J11 is an optional 6-pin power connector used for the power supply which has an identical
connector. The pin assignment and the location of the connectors are as shown below:
Note: * If you change “soft-off by PWR-BTTN” from default “Instant-off” to
“Delay 4 Secs” in BIOS Setup (POWER MANAGEMENT SETUP), the power button
should be pressed for more than 4 seconds before the system powers down.
**This optional signal (-5V) is not available in the SFX power supply.
Hard Disk LED Connector (HDLED)
The connector connects to the case’ s IDE indicator LED indicating the activity status of
IDE hard disk.
10
Installation Instructions
AGP VGA Connector
POW ER
Power Supply Connector (J10)
5V 5V -5V GND GND GND PSON
GND -12V 3.3V
12V 5VSB PS-OK GND 5V GND 5V GND 3.3V 3.3V
1
20
**
NC
NC
Optional Power
Connector(J11)
Fan monitoring
Fan control
3.3V sense
NC
Summary of Contents for ZillioX 6
