6
Safety instructions
HBM
QuantumX
Conditions on site
For modules with degree of protection IP20:
−
Protect the modules from humidity or effects of the weather such as rain, snow, etc.
−
The permissible relative humidity at 31
°
C is 80% (non-condensing); linear reduction down
to 50%, at 40
°
C.
−
Ensure that the ventilation openings on the sides are not covered.
For all modules:
−
Do not expose the instrument to direct sunlight.
−
Observe the maximum permissible ambient temperatures given in the specifications.
Maintenance and cleaning
The modules are maintenance-free. Please note the following when cleaning the housing:
−
Before cleaning, disconnect the equipment completely.
−
Clean the housing with a soft, slightly damp (not wet!) cloth.
Never
use solvents, since
these could damage the labelling on the front panel and the display.
−
When cleaning, ensure that no liquid gets into the module or connections.
General dangers of failing to follow the safety instructions
The module is a state-of-the-art device and as such is failsafe. The module may give rise to
further dangers if it is inappropriately installed and operated by untrained personnel. Any
person instructed to carry out installation, commissioning, maintenance or repair of the
module must have read and understood the Operating Manuals and in particular the
technical safety instructions.
Remaining dangers
The scope of supply and performance of the module covers only a small area of
measurement technology. In addition, equipment planners, installers and operators should
plan, implement and respond to the safety engineering considerations of measurement
technology in such a way as to minimize remaining dangers. Prevailing regulations must be
complied with at all times. There must be reference to the remaining dangers connected with
measurement technology. After making settings and carrying out activities that are
password-protected, you must make sure that any controls that may be connected remain in
a safe condition until the switching performance of the module has been tested.
Working safely
Error messages should only be acknowledged once the cause of the error is removed and
no further danger exists.
Summary of Contents for CX27
Page 1: ...I2720 2 0 en Operating Manual CX27 Gateway ...
Page 2: ...d ...
Page 4: ...4 HBM QuantumX 10 Abbreviations 54 11 Support 55 ...
Page 55: ...55 Support HBM QuantumX ...
