v1.32
March 2014
52 of 90
Use your activity sensor in template mode
1.
Program the activity sensor using the motion software, see
Turn
on your activity
sensor
2.
Program your collar in template mode, see
Create
program in template mode
.
3.
When programming each template you will need to enter
the time period for which you would like your activity
sensor to record data. You may set the activity sensor to
record data during multiple periods throughout each template. After you unplug
the USB cable from the collar there is a 3 minute delay before the activity sensor
begins to work. Then after the 3 minute delay the activity sensor will operate
according to your programmed time periods. However, when the GPS unit is
attempting to acquire GPS satellites and when the unit is connected wirelessly to
the base station, the activity sensor will not operate.
Recovering your data
1.
Open the Motion software.
2.
Connect your GPS to your PC.
3.
Press the download activity data button.
4.
Select the folder location where you would like to save your file and press save. If
there are several thousand pages of motion data it will take some time to
download. Each page of data contains roughly 62 lines of data. The program may
appear to stop working, but it is in fact downloading your data into a file. If your
memory is filled with data it may take up to 30 minutes to download the activity
data. Note: The software auto generates the same name for every download of
activity data. If you do not want to save over old data it is highly recommended
that you change the name before saving it.
5.
To view your data double click on the saved file created by the Motion software
and it will open in notepad.
Summary of Contents for 4000 Enhanced
Page 90: ...v1 32 March 2014 90 of 90...