Chapter 1 Introduction
Operator Accessible Components
8
Quantum|ATL 7100 Series Library Operator’s Guide
Load Port
1
The load port is located at the front of the library above and to the
left of the control panel (see
). It allows an operator to insert
and/or remove up to four tape cartridges (see
for a
description of the load port buttons).
To load/remove cartridges, press the
OPEN
button. When the
indicator stops blinking, the load port door opens and allowing the
operator to insert tape cartridges. To close, press the
CLOSE
button
and push the door to the closed position.
For the unload operation, the gripper places tape cartridges in the
load port bins. Looking through the view port, the operator will be
able to decide if an unload operation is necessary. Pressing the
OPEN
button automatically opens the door allowing the operator
to remove the tape cartridge(s).
FAULT
(Indicator)
The
FAULT
indicator illuminates when the library has an error condition.
The SDA displays the name of the error condition. For a listing and
detailed description of all status messages shown in the SDA, see chapter
3,
Status Display
Area
This is a 16-character, 2-line liquid crystal display (LCD) display. It
displays status messages that describe the operating state of the library. It
also displays menu options when the library is in menu mode.
Caution:
You must release the
CLOSE
button before pushing
the load port door closed.
Control
Library Function
Summary of Contents for ATL 7100
