Appendix
quantum
M A S C H I N E N - G E R M A N Y
©
2
007
GB
Page 56
Drilling machine
B 13 / B14 / B16 / B20 / B25 / B32
Version 1.2.5
18 / 01 / 2008
8
Appendix
8.1
Copyright
©
2007
This documentation is copyright. All derived rights are also reserved, especially those of transla-
tion, re-printing, use of figures, broadcast, reproduction by photo-mechanical or similar means
and recording in data processing systems, neither partial nor total.
The company reserves the right to make technical alternations without prior notice.
8.2
Terminology/Glossary
Term
Explanation
drill drift
tool to release the bit or the drill chuck from the drill
spindle
drill chuck
drill holding fixture
drilling head
upper part of the drilling machine
drill sleeve
fixed hollow shaft which runs in the drill spindle
drill spindle
shaft driven by the engine
drilling machine table
support face, clamping surface
morse taper
cone of the drill or of the drill chuck
sleeve lever
manual control for the drill feed
quick action drill chuck
drill holding fixture to be clamped manually
workpiece
part to be drilled, part to be machined
tool
bit, countersink, etc.
locking pin
pin to hold the drill sleeve at a certain height in order
to disassemble the drill chuck or the tool
