Configuring Local and Remote System Administrators
Quantum Spark 1500, 1600 and 1800 Appliance Series R80.20.40 Locally Managed Administration Guide | 256
To edit the details of locally defined administrators:
1. Select the administrator from the table and click
Edit
.
2. Make the relevant changes.
3. Click
Apply
.
To delete a locally defined administrator:
1. Select an administrator from the list.
2. Click
Delete
.
3. Click
Yes
in the confirmation message.
Note - You cannot delete an administrator who is currently logged in.
To allow access for administrators defined in a remote RADIUS server:
1. Make sure administrators are defined in the remote RADIUS server.
2. Make sure a RADIUS server is defined on the appliance. If there is no server, click the
RADIUS
configuration
link at the top of this page. You must configure the IP address and shared secret used
by the RADIUS server.
3. When you have a configured RADIUS server, click
Edit permissions
.
The
RADIUS Authentication
window opens.
4. Click the
Enable RADIUS authentication for administrators
checkbox.
Use roles defined on RADIUS server
is selected by default.
5. Configure the role for each user on the RADIUS server. See additional details below.
Note - A user without role definition will get a login error.
6. If you select
Use default role for RADIUS users
, select the
Administrators Role
:
n
Super Admin
n
Read only
n
Networking Admin
n
Mobile Admin
7. To define groups, click
Use specific RADIUS groups only
and enter the RADIUS groups separated
by a comma.
8. Click
Apply
.
