Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-05 Rev B
April 2012
VTL Configuration CLI Commands
19
If the
--useccl
option is specified, the Command and Control LUN feature is
enabled.
Note:
The CCL (Command and Control LUN) is not used in most
environments. This option is recommended for host access groups that
contain an HP-UX host. It can also be used if hosts that are not
assigned to any host access group exist in the SAN. The CCL is
accessible to hosts only through LUN 0.
Caution:
If you are not sure if you should use CCL, contact Quantum
Customer Support before you enable this option.
Deleting a SAN Client
Group
syscli --del sanclientgroup --name <VTL_name> --groupname
<group_name>
This CLI command allows the CLI admin to delete a SAN client group given the
required VTL name and the group name.
Listing VTL Storage
Locations and Index
syscli --list vtlstorage --name <VTL_name> --loc source | dest [--type drive |
slot | ieslot]
This CLI command allows the CLI admin to list the source and destination
storage locations. This is useful to determine the locations to move or unload
media command. If the
--type
option is specified, only locations of the specified
type is listed.
Below is a sample output of this CLI with a VTL name and destination location
specified:
syscli --list vtlstorage --name VTL1 --loc dest
Output data:
List
of
VTL
storage
locations:
Total
count
=
4
[storage
location
=
1]
location
type
=
I/E
Slot
index
=
0
drive
serial
number
=
N/A
barcode
=
N/A
writeprotect
=
disabled
access
=
N/A
used
=
N/A
[storage
location
=
2]
location
type
=
I/E
Slot
