Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-05 Rev B
April 2012
22
NAS Configuration CLI Commands
Listing the Existing NAS
Share and Attributes
syscli --list share [{--proto cifs|nfs} | {--name <share name>}] [--
namematch <pattern>]
This CLI command provides a list of all existing NAS shares on the system and
their attributes. The list can be limited to the type of protocol if
--proto
is
specified. If
--name
is specified, only the attributes of that share are listed.
CLI command options:
•
--list
: Lists all NAS shares.
•
*
--namematch
: If specified, only shares whose names match the specified
pattern are listed. The wild characters
^
and
$
are supported as follows:
• ^xxx – matching pattern xxx at the start of names
• xxx$ – matching pattern xxx at the end of names
Remember to escape
$
with a backslash because it is special to the shell. For
example, to list all shares ending with
test
in the names, type the following:
syscli --list sharename --namematch test\$
Note:
Option marked with (
*
) means not supported in Web Services.
Listing of Existing NAS
Share Names
syscli --list sharename [--proto cifs|nfs] [--namematch <pattern>]
This CLI lists all share names for both CIFS and NFS. If
--proto
is specified, only
names of shares associated with the specified protocol will be listed.
CLI command options:
•
--proto
: If specified, limits the listing to the specified protocol.
•
--namematch
: If specified, only shares whose names match the specified
pattern are listed.
The wild characters ^ and $ are supported as follows:
• ^xxx — matching pattern xxx at the start of names
• xxx$ — matching pattern xxx at the end of names
Remember to escape
$
with a backslash because it is special to the shell. For
example, to list all shares ending with
test
in the names, type the following
command:
syscli --list sharename --namematch test\$
Alternately, you can list a single share with the following CLI command:
syscli --get share --name <sharename>
Getting the Total NAS
Share Count
syscli --getcount share [--proto cifs|nfs] [--namematch <pattern>]
This CLI displays the total count of NAS shares defined in the system.
CLI command options:
•
--proto
: If specified, displays the count for this protocol only.
•
--namematch
: If specified, only shares whose names match the specified
pattern are counted.
