Installing the DXi4700 System in the Rack
Quantum DXi4700 Installation Guide
46
Make sure to align the pins correctly with the holes, as inserting them in the wrong holes may bend
them. The top of the rail front end should be flush with the desired line on the vertical rack flange.
2. Align each back end piece in the bottom and top holes of the desired U spaces.
3. Engage the back end of the rail until it fully seats on the vertical rack flange and the latch clicks into
place. Repeat these actions to position and seat the front end piece on the vertical rack flange.
Removing the Rails
If you need to remove the rails, use a flat head screwdriver to lift the latch release button on the end piece
midpoint and unseat each rail.
Figure 34:
Node Rails Installation
1
2
3
4
