Configuring the DXi4800
At a minimum, you must complete the following steps to get your system up and running.
See
Install > DXi4800 System Installation > Perform Initial Configuration
You can configure and schedule replication as needed.
See
Operate > DXi4800 User Guide > DXi4800
6-68760-01 Rev A
©2019 Quantum Corporation. All rights reserved.
Page 2
*6-68760-01*
Operating the DXi4800
Step 1
Access the Remote Management Console.
Step 2
Complete the Getting Started Wizard.
Step 3
Upload the new DXi software.
Now that the DXi4800 is up and running, you can monitor the health of system components, replication
and data reduction statistics, and activities. See
Operate > DXi4800 User Guide > DXi4800 Status
Using the Status page, you can view
information about:
•
Hardware
•
Virtual tape library components
•
Accent status
•
OST status
•
Activities
Step 4
Connect the Ethernet cables. For a video, click the
video link in the following section:
System Installation > Perform Initial configuration >
Step 4
Step 5
Install the front bezel.
Step 6
Install the Capacity license.
Step 7
Configure email reports and other functions using the configuration wizards.
