Rear Panel
LightSpeed Appliances Getting Started Guide | 61
To install the power cable restraint on QLS250, QLS450, QLS650, QLS800, and MLS400
1. If a power cable is connected to the power supply inlet, disconnect it.
2. Find the restraint strip slot on top of the power supply inlet.
3. Make sure that the cable loop on the restraint faces the power supply inlet.
4. Insert the restraint strip anchor into the slot until it snaps and locks.
5. Connect the power cable to the power supply inlet.
6. Pull the restraint tab to the side to move the cable loop on the restraint strip.
7. Move the cable loop until you can put it around the power cable as shown in the next figure.
8. Insert the open side of the cable loop into the loop slot until it is tight against the power cable.
9. Make sure the cable loop is secured and the power cable cannot be removed.
To secure the power cable restraint on MLS200
The MLS200 appliances have a power cable restraint clip attached to the power supply unit (PSU). Use
the restraint clip to prevent accidental removal of the power cable.
1. Make sure the restraint clip is in the open position (upward).
2. Connect the power supply cable to the power supply inlet on the PSU.
