Restoring Factory Defaults
LightSpeed Appliances Getting Started Guide | 72
Restoring from the Boot Menu
To restore the appliance from the Boot Menu:
1. Connect the supplied serial cable's RJ45 or USB type-C connector to the console port on the front of
the appliance.
2. From the computer, open a terminal emulation program such as PuTTY or Microsoft HyperTerminal.
3. Configure the terminal emulation program:
n
In PuTTY select the
Serial
connection type.
n
In the HyperTerminal
Connect To
window, select a port from the
Connect using
list.
4. Configure the serial connection settings:
9600 BPS, 8 bits, no parity, 1 stop bit, Flow control - None
5. Connect to the appliance.
6. Reboot or turn on the appliance.
The appliance initializes and status messages are shown in the terminal emulation program.
7. When the message "
Press any key to see the boot menu
" appears, you have approximately four
seconds to press any key to open the
Boot
menu.
8. From the
Boot
menu, select the applicable
Reset to factory defaults
image.
9. Press
Enter
.
The appliance initializes and status messages appear in the terminal emulation program.
Restoring from Gaia Clish
To restore the appliance from Gaia Clish:
1. Connect to the command line on the appliance.
2. Log in to Gaia Clish.
3. Run:
set fcd revert<SPACE><TAB>
set fcd revert <
Name of Default Image
>
4. Follow the instructions on the screen.
5. Reboot the appliance:
reboot