©
200
4
GB
Page 23
29 June 2005
Version 1.1
QSM
Bench grinder
Appendix
quantum
M A S C H I N E N - G E R M A N Y
6.3
Warranty
Within the term of warranty, the company Optimum warrants for a perfect quality of its products
and will reimburse any cost for overhaul or exchange of defective parts in case of construction
error, fault in material and / or defect of fabrication.
The term of warranty for commercial use is 12 months and for use as an amateur it is 24
months. Condition for a warranty claim due to construction errors, faults in material and / or
defects of fabrication is:
•
Proof of purchase and that the instructions for use had been followed.
In order to assert the claim of warranty, you have to present a typescript original receipt of
purchase. It must comprise the complete address, date of purchase and type designation of
the product.
The instruction for use for the corresponding device as well as the safety information are to
be observed. Damages due to operator’s mistakes may not be accepted as warranty claims.
•
Correct use of the devices.
The products of the company Optimum had been designed and built for certain purposes.
They are listed in the operation manual.
The warranty claim may not be accepted if the operating manual is not being followed pro-
perly or if it is used for a purpose which has not been intended or with improper accessory.
•
Maintenance work and cleaning.
It is absolutely necessary to maintain and clean the machine in regular intervals according to
the prescriptions of the instruction for use.
By intervention of a third party, any warranty claim will expire. Maintenance work and cle-
aning are usually not part of the claim of warranty.
•
Original spare parts
Make sure to use only original spare parts and original accessory. This can be acquired from
authorized distributors of the machine.
When other than original parts are being used, consequential damages may occur and dan-
ger of accidents will increase. Disassembled or partially disassembled devices and devices
which are repaired with foreign parts are excluded from warranty claims.
•
Wearing parts
Certain components are subject to wear out by time respectively a standard wear by use on
the corresponding machine.
Among these components are e.g. V-belts, ball bearings, switches, mains cables, gaskets
and washers, etc. These wearing parts are not part of the warranty.
