14
Basic Operations
Turn Radio On/Off
Press the power switch to turn on the radio.
press and hold down the power switch for about 1 second to turn off the radio.
Adjust the Volume
Turn the Volume Control Knob clockwise to increase the volume, or counter-clockwise to
decrease the volume.
During adjusting, please note that if the radio is programmed with CTCSS/CDCSS
or2-Tone signalling squelch, noise will not be heard from local speaker even though you
turn the volume control knob fully clockwise.
Select Power Level
If the current channel is programmed with high power by your dealer. the power output
toggles between high and low upon each press the programmed Tx Power Select key.
The
“
LO
”
icon is displayed on LCD while using low power.
A higher level means you can reach a radio that is farther away. A lower power level saves
battery and reduces the possibility of interference. Use the high power setting only when
necessary
Note:
●
If the current channel is programmed with lower power press the Tx Power Select key
prompts an error tone and the power level will not change.
●
If you switch to low power on a channel that was set with high power, this configuration
is done on all other channels that were set with high power.
Select a Channel
The [
▲
]/[
▼
], [F1]-[F4] function keys are programmable by your dealer to select a channel,
The RX/TX frequency on each channel is set by your dealer.
Press the [CH Up] key (programmable) to select a higher numbered channel; press the
[CH Down] key (programmable) to select a lower numbered channel.
Channel Annunciation
If the feature is enabled by your dealer, the current channel number will be heard when
you press the channel select key.
Note:
Please select the volume level as "1", when using an Easy-VOX earpiece
accessory.
Select a Zone
The [
▲
]/[
▼
], [F1]-[F4] function keys are programmable by your dealer to select a zone.
