15
Press the programmed [zone Up] key to select a higher numbered zone; press the
programmed [Zone Down] key to select a lower numbered zone.
Receive a Call
If CTCSS/CDCSS, DTMF/2-Tone/MDC1200 is set on the current channel by your dealer,
you can receive calls with matched signalling only,
If CTCSS/CDCSS, DTMF/2-Tone/MDC1200 is not set, you can hear from all the users on
the same channel.
Send a Call
1. Hold down the [PTT]
2. Speak into the microphone. The red LED lights while calling.
3. Release the [PTT] to return to the receive mode.
4. When transmission ends, put the microphone on hook.
BOT ID and EOT ID
Your dealer may configure whether to transmit connect ID (BOT ID) and Disconnect ID
(EOT ID), when connecting or disconnecting a repeater or telephone system. The
following modes are programmable.
1. BOT ID occurs on each press of [PTT].
EOT ID occurs on each release of [PTT]
2. Press the [*] while holding down the [PTT], then BOT ID is transmitted.
Pres the [#] while holding down the [PTT], then EOT ID is transmitted.
VOX Operation
When hands-free operation is desired, your radio can be activated by voice alone using
the VOX feature when you speak through an accessory that is connected to your radio.
z
Connecting a Easy-VOX Microphone
1. Turn off your radio.
2. connect the VOX accessory to your handset microphone and turn the radio on.
z
Enabling or Disabling VOX
To enable or disable VOX operation, press the preprogrammed VOX button
Note:
Pressing the PTT button disables VOX.
