Quantum R-net, Basic Operation Instructions

10

Mode Button (Actuator Adjustment for Optional Equipment)

The mode button is used for optional equipment such as a power elevating seat or power elevating leg 

rests. For specific operation of the actuator buttons, refer to “Actuator Adjustment.”

Profile Button

The profile button is used to change the drive profile. The R-net Controller can be programmed with up to 

five (5) drive profiles. The current profile is displayed on the LCD screen.

NOTE: The speed/profile increase and speed/profile decrease buttons are used to change the 

drive profile on controllers equipped with an LED keypad.

To change the drive profile:

1.  Push the on/off button to power on the chair and the controller.

2.  Press the profile button to select the next available profile.

3.  Once the desired profile is displayed, the drive screen will be displayed after a momentary pause.

Right/Left Turn Indicator Buttons and LEDs (for Optional Equipment)

The right/left turn indicator buttons toggle either the right or left turn indicators. The appropriate LED will 

illuminate when the turn indicator is activated. Press once to turn on and press again to turn off. You can 

also turn off the selected turn indicator by pressing the opposite indicator button or the hazard button.

Speed Increase/Decrease Buttons

There are two buttons that control the speed of your power chair. Press the speed increase button to 

increase the speed. Press the speed decrease button to decrease the speed. For controllers equipped 

with an LCD screen, the maximum speed of the current speed setting is displayed on the maximum speed 

indicator. The current speed is also displayed on the LCD screen. For controllers equipped with LEDs, the 

maximum speed of the current speed setting is displayed on the maximum speed/profile indicator.

NOTE: The speed settings are preset at the factory. If your Pride/Quantum Rehab Provider changes 

the order of these settings, please make note of these changes. Contact your Pride/Quantum 

Rehab Provider for more information.

NOTE: We recommend that the first few times you operate your power chair, you set the speed to 

the slowest setting until you become familiar with your new power chair.

Battery Condition Meter

The battery condition meter is located at the top of the LCD screen. This is a 10-segment illuminated 

display that indicates that the R-net is powered on and also gives the battery status, the R-net status, and 

the electrical system status.

„

Red, yellow, and green lights lit:

 Batteries charged; R-net and electrical system OK.

„

Red, yellow, and green lights flash slowly:

 Charge batteries as soon as possible; R-net and elec-

trical system OK. 

„

Lights Stepping Up:

 The batteries are being charged. Once charging is complete, disconnect the 

charger and then power the controller off and then on again.

„

Red, yellow, and green lights flash rapidly:

 The R-net has detected a problem. Refer to “Fault 

Codes.”