Chapter 5 Running Diagnostic Programs
Running the Move Location Test
92
Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library User’s Guide
14
Press
Left
to move the highlight to the next number.
15
Repeat steps
and
as necessary until the desired cycle
count number is displayed.
16
Press
Right
until the cursor is all the way to the right and the
Select
button appears.
17
Press
Select
to set the cycle count, or press
Cancel
to return to
the
Diags: General
screen without running the
Move Medium
test.
The test starts and the GUI displays a
Running Diag
screen. The
test stops automatically after completing the selected number
of cycles. When the test is complete, the GUI displays a screen
indicating the test status.
To abort the test before it completes the selected number of
cycles, press
Stop
.
18
Press
Back
.
The GUI displays the cycle count screen.
19
Press
Cancel
, then
Back
to return to the
Diags: General
screen.
Running the Move Location Test
5
The
Move Location
test is similar to the
Move Medium
test, except
that no cartridges are actually moved.
When the
Move Location
test is cycled once, the robotic hand is
moved from its current location to the destination location.
When the
Move Location
test is cycled more than once, the robotic
hand is repeatedly moved between the destination location and a
home location, and will return to the home location at the end of
Note:
Setting the cycle count to
0000
causes the test to run
continuously.
Summary of Contents for Sun StorEdge L100
Page 10: ...Figures x Sun StorEdge L25 Tape Library and Sun StorEdge L100 Tape Library User s Guide...
Page 12: ...Tables xii Sun StorEdge L25 Tape Library and Sun StorEdge L100 Tape Library User s Guide...
Page 192: ...Index 176 Sun StorEdge L25 Tape Library and Sun StorEdge L100 Tape Library User s Guide...
