21
BASIC OPERATION INSTRUCTIONS
Figure 25. Laterals
NOTE: Laterals should be installed and adjusted by your
Quantum Rehab Provider.
NOTE: If the power chair is occupied when installing
or adjusting the laterals, first ensure that the occupant
is in a secure position. Contact your Quantum Rehab
Provider with any questions you may have.
To install laterals:
1. Remove the plastic shroud from the lateral extrusion on
the side of the seatback.
2. Insert the square slab nut—with its arrow pointing up—
into the slot of the lateral extrusion.
3. Install the lateral support into the lateral extrusion.
See
figure 25.
4. Insert the spacer and the two (2) bolts through the
lateral support and the square slab nut. Do not tighten
completely.
5. Slide the lateral support to the desired height and width.
6. Tighten the bolts inserted into the lateral extrusion.
7. Reinstall the plastic shroud on the lateral extrusion.
8. Repeat for other side, if necessary.
To adjust the laterals:
1. Loosen the two (2) bolts in the lateral extrusion.
2. Slide the lateral support to the desired height and width.
See figure 25.
3. Tighten the bolts inserted into the lateral extrusion.
4. Repeat for other side, if necessary.
Plastic shroud
Square
slab nut
Lateral support
Lateral extrusion
Summary of Contents for TRU-BALANCE 3
Page 24: ...24 BASIC OPERATION INSTRUCTIONS...
Page 25: ...25 BASIC OPERATION INSTRUCTIONS...
