Chapter 3 Setting Up the Autoloader
Installing the Autoloader into a Rack
LTO Ultrium 8-Slot Autoloader User’s Guide
17
Figure 8 Rack Mount
Kit
Preparing the
Autoloader
3
If the autoloader is currently in operation as a standalone unit, prepare it
for installation in the rack as follows:
1
Power off the autoloader by pressing the right side of the recessed
power switch located on the autoloader’s front panel. Use the eraser
end of a pencil or a similar object to press the power switch.
Warning:
Before performing any installation or maintenance
procedures, be sure that the power switch is off and that
the power cord is disconnected from the autoloader and
the AC outlet.
Note:
To avoid disrupting communication between the host
computer and other devices on the SCSI bus, make sure
that there is no SCSI activity on the bus before you power
off the autoloader.
Rack-mount brackets
Support rails
Screw
Clip-nut
