Chapter 3 Setting Up the Autoloader
Installing the Autoloader into a Rack
20
LTO Ultrium 8-Slot Autoloader User’s Guide
• Slide the autoloader into the rack until the bracket you are
holding contacts the rack’s mounting holes.
• Determine whether the screw hole on the bracket flange lines up
with a mounting hole in the rack. If it does, you will mount the
bracket on that side of the autoloader. If not, you will mount it on
the other side of the autoloader.
2
Remove the autoloader from the shelf and place it on the work
surface.
3
Using a TORX T-10 screwdriver, remove the two screws on each side
of the autoloader.
4
Position the correct bracket, as determined in step 1, on each side of
the autoloader. Secure each bracket by replacing the original screws.
Figure 11 Securing
the Brackets
Securing the
Autoloader
3
To secure the autoloader to the rack:
1
From the front of the rack, position the autoloader on the shelf
flanges between the support rails. Slide it toward the rear of the rack
until the brackets contact the rack’s mounting holes. Make sure that
the tabs on the back of each shelf flange are fully engaged in the slots
at the rear of the autoloader.
PO
W
ER
M
EN
U
-
+
SE
LE
C T
Flange
Rack-mount bracket
