Quark-elec Manual
6 of 8
2018
V2.0
7. Operating
Once AT011 has been configured, it can be used without computer, but 5V power should be supplied
through USB port. It will stop transmit once the amount of the repeat message has been send out. By
un-plugging from the USB and plugging it back in again. The terminal will reset and continue the
repeat message again.
The red LED will turn on after power up. The green LED will flash if there is AIS send out.
Figure 1: AT011 Connection Diagram
Ten random named vessels will be moving with random speed within the setting area until lthe repeat
times reached. .
Figure 2: Messages shown on OpenCPN
