3.3 Frequently Asked Questions
Basic Configuration List Not Available:
A problem noted on some systems is after a basic configuration has been manually selected the
basic configurations list for the SSP-100 is no longer available. The solution to this problem is
to check the “Use Automatic Settings” box and allow Windows 95/98/ME to reconfigure the
SSP-100 card. The basic configurations list should once again be visible.
Base I/O Address Resource Modification Not Allowed:
The SSP-100 is configured to allow only a fixed number of base I/O addresses. To change the
I/O address resources for the SSP-100 select another “Basic Configuration”. Refer to the Basic
Configurations table for a list of the availabe I/O address resources for the SSP-100
3-4
SSP-100
(Rev. G and later)
User's Manual
Summary of Contents for SSP-100
