IMPORTANT INFORMATION
TECHNICAL DETAIL
QUATREAU 553-B
QUATREAU CHILLER CARBONATOR CS20
POWER REQUIREMENTS
1 x 13A socket
1 x 13A socket
(RCD Protected)
VOLTAGE 220V
220V
WATTAGE
Max consumption
1.5KW
296W
Standby consumption
80W
100W
START UP TIME
10 minutes
10 minutes
MAX WORKING PRESSURE Max 4Bar (Min 2Bar)
30 psi
CO2 CAPACITY
100ltrs carbonated water
INSTALLATION DETAIL
BY AUTHORISED QUATREAU TECHNICIAN ONLY
INSTALLATION DATE
INSTALLATION NOTES
Installation of the Quatreau Touch is best achieved using the following
sequences:
1. Site the equipment to check it all fits, chiller to the left of the boiler.
2. Install the TouchTap (note the comms cable must reach the boiler
control unit).
3. Install Thermostatic mixing valve and set to maximum temperature
then reduce by 1/2 turn for 40C set point. Connect the hot and
cold feeds with isolators.
4. Install Drain off saddle with type AA air gap (rear left corner of
cupboard).
5. Cut the ventilation for the chiller.
6. Fit the boiler control unit using the silicon hoses included in the kit.
7. Connect the mains hot and cold to the left side of the boiler and
test for water tightness.
8. Connect the cold feed to the top front right side of the boiler and
activate testings for water tightness.
9. Connect power cable but do not turn on.
10. Connect the comms cable from the TouchTap.
11. Fit the chiller unit and make all interconnections pure outlet and
CO2 outlet into boiler and the chilled and sparkling outlets back
into the boiler.
Then read the commissioning Instructions.
CONTACT
www.quatreau.com
INSTALL ATION
