Page 11
© Quatro Air Technologies| JULY 2019 | All rights reserved |
Jet-Stream Tall Operation & Maintenance Manual
i Series Controls
NOTE:
When operating by remote control the use of the On/Off (Power) button on the panel is disabled while the
Remote/Standby light is ON Solid Or Fading In And Out .
If you wish to use the On/Off button on the panel after Remote Operation has been enabled the function is only available
when the Remote/Standby light is flashing slowly. While in operation via the ON/Off (Power) button, remote operation is
temporarily disabled. Turn the unit off with the ON/Off (Power) button to go back into Remote Operation.
Remote (Automatic) Operation and Remote Status
The Quatro System is designed to be used with other pieces of equipment that can support remote operation and/or
remote status monitoring . The connection is made using the AE427 QUATRO Universal Remote Cable .
QUATRO has some custom remote cables for specific applications. Contact us for more information on available
applications and part numbers . The Quatro System supports Closed Contact and 1-30V AC or DC remote operation as
well as Remote Status signals .
NOTE: Switching power to control the QUATRO System system remotely WILL NOT WORK and can damage
the unit.
Temporary ON Mode
allows you to temporarily override your automatic remote control of the system to perform a quick
cleaning of work surface. Temporary ON Mode is only available when the Remote/Standby (L5) light is flashing slowly.
Use of this mode will temporarily BLOCK OR DISENGAGE all other functions .
To initiate:
•
Press POWER (On/Off)
button to start unit, System ON LED will FADE In-Out, unit will start .
•
When you finish using this feature, press POWER (On/Off) again. All other functions will be unblocked.
DB9 Pin Out Information
Jet-Streams support remote operation . Connect the AE427 remote cable in between the Quatro System and the other
piece of equipment using only the wires required as per the diagram below .
