QUATRO
Air Technologies Inc.
---------------------------------------------------------
Engineers Of Clean Air
--------------------------------------------------------
30 Hymus Boulevard, Montreal, Quebec, H9R 1C9 Tel.: (514) 630-4444 Fax: (514) 630-4454 website:
www.quatroair.com
info@quatroair.com
Operations & Maintenance Manual
PowerStation, PS6 Series
INSTALLATION, FREE-STANDING MODEL
The unit is shipped in the upside-down position, casters are factory installed, 2 models available,
All items below are shipped in a separate box:
Model
Ships with:
PS625-2370-0
(2) F022 HEPA filters, (6) AG259 YELLOW filter bags, (4) Galv Filter Separators,
O&M Manual, Hose and fittings are added separately depending on application.
PS625-23AZ6GH
(2) F022 HEPA filters, (6) AG149 WHITE filter bags, (2) Galv Filter Separators, O&M
Manual, (2)inlet plates(3x1.5”dia),50ft 1.5”dia suction hose, 240v PowerCord(#E302),
Foot-pedal (AA175),
(6) Rubber hose fittings, (6) 2”wide x ½”thick gaskets for rubber hose fittings:
Connect to 1.5” dia: use hose directly
Connect to 2” dia: use Rubber Hose fittings to connect
Connect to 2.5” or 3”dia: use ½” thick gaskets around Rubber hose Fittigns to make
up the dimension
Your option to install unit on (6) stationery rubber feet or (4) mobile casters (install 2
lockable casters in front)
1) Install Rubber feet or casters
2) Open filter door, remove plastic around HEPA filter, install HEPA filter, Grating and filter bags
3) Plug Power Cord to a grounded 240-volt wall outlet
4) Connect to individual workstations
SYSTEM IS MORE EFFICIENT WHEN CONNECTING EACH WORKSTATION INDIVIDUALLY
START-UP
1) Plug the unit into a 220-240v wall outlet with the cord provided (socket is on side of unit)
2) After 10seconds, switch ON using RED POWER button on control panel to ensure unit STARTS
“System ON” LED illuminates, indicates unit is operating
2) Press POWER button again to switch unit OFF
3) You are now ready to operate
4) Install Foot-Pedal (#AA175) into the db9 (9-pin socket on side of unit) to start/stop unit remotely
If: “System ON” LED is OFF (indicates unit NOT operating)
If: “Remote/Standby” LED flashes (indicating unit is in WAITING MODE)
PS6 is shipped on a
pallet, in an Upside-
Down Configuration
Accessories shown
on top are shipped in
a box, placed on top
of the unit
