a
a
PW TECHSAM Woch Sp. J.
tel.
81 444-63-73
ul. Warszawska 131
tel.
81 443-08-12
20-824 Lublin
fax
81 458-38-19
e-mail:
IMPORTER
:
TO RISE
1.
With one end of jack handle, close release valve tightly by turning it clockwise.
2.
Place vehicle in PARK (in gear on standard transmission) and apply emergency brake.
3.
Place jack under vehicle at proper lifting location. (Refer to vehicle Owner’s Manual). If needed, turn extension screw on
jack counter clockwise until it comes in contact with vehicle.
4.
Insert jack handle into handle socket. Pump the handle to lift vehicle to desire heights.
TO LOWER
1.
Remove handle use small end to SLOWLY open release valve. To open, turn SLOWLY in counter-clockwise direction.
2.
When vehicle fully lowered, remove jack. If extension screw has been extended, turn it clockwise until it retracts enough to
remove from vehicle.
3.
When jack has been removed from vehicle, close release valve for storage.
GENERAL CARE
-
When jack is not in use lifting arm and pump lever should be in full down position. This will protect precision machined
surface of the arm and the piston from corrosion.
-
Container is filled with 7fl.oz of hydraulic jack oil.
-
Keep your jack clean and well lubricated as well as the outside moving parts such as the lifting arm spindle, wheel bearings
and cross head pin.
-
Should any other parts be required please refer to the sectional drawings and quote appropriate serial number of the jack
when ordering.
-
ADDING OIL: With arm fully lowered
and jack on level ground, remove oil fill plug. Add oil if level is more than ½” below
hole replace cover plate.
-
REPLACING OIL: Oil should be replaced at least once a year. To drain oil, remove cover plate. Oil filler plug and release valve.
Be VERY CAREFUL to not allow dirt and any foreign matter into the system.
-
LUBRICATION: Put grease in fitting on base and lubricate lifting arm spindle with oil every 3 months.
-
RUST PREVENTION: Clean and wipe with oily cloth the piston ram and pump piston every 3 months or when signs of rust or
corrosion appear. When not in use always leave the saddle and pump piston in the completely down position.
TROUBLE
CAUSE
REMEDY
Jack will not lower completely
1. Air in hydraulic system
2. Release valve stuck
1. Purge air from hydraulic system
2. Transfer weight load and clean
valve
Jack will not lower weight
1. Release valve in open
position
1. Close release valve tightly
Jack will not lift to full height
1. Oil level low
2. Air in hydraulic system
1. Fill to recommended level
2. Purge air from hydraulic system
Weak lifting
1. Air in hydraulic system
2. Dirty oil
3. Release valve not
completely closed
1. Purge air from hydraulic system
2. Change oil use SAE 5W
3. Close release valve tightly
Jack will not lift
1. Excessive weight
2. Release valve in open
position
3. Oil level low
1. Decrease weight or change to
higher capacity jack
2. Turn valve clockwise and tighten
3. Fill to recommended level
