Changing batteries in the remote control:
Open the rear cover of the handset by pushing gently and sliding the rear cover in the direction of the
arrow (Fig.2). Take out the depleted/old batteries and dispose in the appropriate way (check with your
local authority for correct disposal of batteries). Install new replacement batteries. Make sure to use leak
proof batteries (No claims under guarantee can be considered for damage caused by leaking batteries).
Slide the rear cover on gently and it will click into place.
The Electronic Control Unit (3), which is mounted inside your caravan, is responsible for controlling the caravan mover.
The control unit has three LED’s (Fig.3) and one recessed button (Fig.3A):
Green LED – This will illuminate when receiving the signal. The LED will flash if the remote control is out of range (the
maximum range is 100 metres – without obstruction).
Blue LED –
This will illuminate if the temperature of the control unit is too high, or if the battery voltage is
too low or too high.
The Red LED will specify the error as follows:
Red LED –
Voltage too low <10V: LED will flash twice slowly.
Voltage too high >15V: LED will flash fast 5 times.
Electric current is too high (≥120A): LED will constantly flash.
Temperature is too high >80C: LED is on permanently.
Reset Button (Fig.6A) – This only needs to be used when replacing a remote control handset. Refer to the ’Before First
Use - Pairing the Handset and Control(s)’ section for reference on this procedure.
When the Control Unit is connected to power, it will perform a self-test automatically. The 3 LEDs will illuminate for 0.2
seconds, and turn off, which means there is no error and the unit is functioning correctly.
As a safety feature the Control Unit will switch off automatically if no button is pressed within 60 seconds. The Control
Unit will also turn off automatically if the mover is working constantly in one direction for longer than 3 minutes.
Operation - Electronic Control Unit
Before First Use - Single Axle and Twin Axle Modes
The following procedure depends on whether you are using the Quattro® electronics for a single axle or twin axle caravan:
To enable Single-Axle Mode: Install only 2 of the 3 ‘AAA’ batteries into the battery compartment of the handset (Fig.5).
Hold down button (E) as shown in Fig.3 and, at the same time, install the final battery. The handset will sound single beeps.
The electronics will now operate in single-axle mode.
When operating a full Quattro® four motor twin-axle system, only one handset is used to communicate with both Control
Units. The handset will need to be paired or linked to both control units using the following procedure:
Press the Reset button (Fig.3A), the green LED will flash for 10 seconds. Press the power button on the handset twice
whilst the Control Unit’s LED is still flashing. The green LED will then be on without flashing. The remote control and
Control Unit are now paired. Repeat this procedure with the second Control Unit.
Before First Use - Single Axle and Twin Axle Modes
To enable Twin-Axle Mode: Repeat the above procedure but hold down button (G) as shown in Fig.1. The handset
will sound double beeps. The electronics will now operate in twin-axle mode. This mode is used for twin-axle caravan
installations that use two or four motors.
Before First Use - Pairing the Handset and Control Unit(s)
