Page 4
Fig.2
A: Drive Roller
B: 12V Motor
C: Connection Terminals (+ and -)
D:
Base
Unit
E:
Drive
Unit
F:
Gear
Housing
Always ensure that you are close enough to engage the caravan’s handbrake when manoeuvring on uneven terrain and
gradients/slopes in case of mechanical failure. Do not use the mover as a brake, when you have finished manoeuvring
always engage the caravan’s handbrake.
SAFETY FIRST! Ensure that there are no persons or obstructions in the vicinity of the caravan prior to testing.
Please make sure you read the safety instructions very carefully and make sure that you follow these guidelines!
Make sure that the battery that supplies the mover is fully charged and in good condition.
Make sure that the caravan is free from the vehicle and the handbrake is on. Also make sure that the corner-
steady feet are fully raised.
Engage both rollers as described in ‘Operation-Mover engagement’. For the Quattro500 (Manual) this only needs to be done on
one side of your caravan since the other side will automatically follow via the cross actuation bar.
Turn on the Battery Power Isolation Switch (29).
Before operating the Mover, release the handbrake.
Store remote control in a safe place (out of reach of children or other unauthorised people.
The Remote Control handset (2) is powered by two ‘AA’ 1.5V batteries (refrain from using lower voltage rechargables), and is
activated by double-pressing the button (Fig.1C). Once activated the display will illuminate. If the handset has not been used 60
seconds it will power off. Ensure before continuing that the control unit has power by turning on your isolation key.
Fig.1
A = Handset display
B = Directional thumb stick
C = Multi-function button
After the handset has completed powering on the following homescreen will shown on screen. Note if any icons are flashing this
indicates an issue, or that the handset hasn’t connected to the control box. Ensure isolation key is turned on before powering on
the handset, and allow up to 10 seconds for a connection to be established.
Page 5
Operation - Remote Control Handset First Use
A
B
C
D
E
(A) Signal strength
- Indicates signal strength between handset and control unit inside the
carvan.
(B) Mover engagement status
- Circles touching indicates movers are engaged onto wheels.
- Circles seperated indicates movers are disengaged.
(C) Leisure battery status
- Indicates voltage level of leisure battery, for maximum perfor-
mance ensure battery is fully charged and showing 4 bars before operating mover.
(D) Handset battery status
- Indicates handset battery level.
(E) Mover orientation
- This shows the direction of travel of the caravan, when the thumb
stick is moved the caravan will follow in this direction. By default the hitch is designated as
the forward direction. At any time press the multi-function button (Fig.1C) to flip the caravan
orientation, the rear of the caravan will then move forward when the thumb stick is moved
upwards.
Caravan orientation flipped
QUATTRO500_ELECTRONICS_UM.indd 7
15/08/2019 16:47:54
